3/30/2021 0 Comments Codesoft 6 Dongle Driver
It seems that version 5.x of ESXi is no longer incorporating physical parallel port integration (read output ) as was previously avaialble in versions ESXi v3.x 4.x.Ive also confirmed this per page 131 of the ESXi user manual, Note: If you are changing the parallel port on a virtual machine that runs on ESXi 4.1 or earlier host, you can send output to a physical parallel port on the host or to an output file on the host.This option is not available with ESXi 5.0 or later.) I can definitely understand shelving legacy type devices and support but, of all things, physical parallel port output Before I found that little caveat, as quoted from the ESXi 5.0 user manual, Id tried a USB-to-parallel adapter, a couple of cheap cards and even the only card I could find (per the forums) that was known to have worked (the Axxon AXLF616KB parallel port PCI card).
Admittedly, though, that last card was from an ESXi v3.x posting in the forums.but I was pretty much desperate at this point, especially considering that, to replace this parallel port, dongle-driven software, would be about 9,000 Is there simply no way to output to a physical parellel port with ESXi v5.x. Specifically the dongle security interface port (parallel port for your case), must be physically visible to the protected dongle device driver package. This is to permit the required bit-banging handshakes that occur between the protected sw and the protection dongle key. Specifically, ESXi 4.1 or earlier host, you can send output to a physical parallel port on the host or to an output file on the host. This option is not available with ESXi 5.0 or later. So, ESXi 4.1 or earlier host does not support a physical parallel port on the host. Please contact us for further support. Thanks. Regards Kumar Bhatia kumaratsoftio.com Axxon Computer Corporation. Ive attached the.PDFed page from the ESXi 5.x manual. I would love for ESXi to be able to support parallel port pass-through, but I dont believe it does. PLEASE, prove me wrong. This is one of the few times I would welcome it ) Jointly, I spoke with a VMWare engineer about this issue. He stated he was aware that parallel port pass-through was no longer supported and Id postulated if upgrading from ESXi v4x to 5.1 would grandfather-in the setting (as a greyed out, albeit active option). Codesoft 6 Dongle Upgrade To V55After several days, he replied, My engineer confirmed that an upgrade to v55.1 will deactivate parallel pass throughso its not grandfathered in from the previous configuration. At this point, I think the only solution would be to run the server on an older version of ESXi. If you feel there is a viable work-around for this functionality, I would most assuredly be interested in speaking with you and troubleshooting. You are welcome to PM me with your contact information, or I can PM you with mine. Specifically, if it is not too much trouble and you are a friendly tester: a) apply the ESXi 5.1 release but note the possible panic issue which is reported to be resolved as documented in KB 2039030. Contact Us Terms of Use Privacy Accessibility Site Index Trademarks Help Feedback.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |